partial replacement of cement b y granite cutting

  • EXPERIMENTAL INVESTIGATION ON CONCRETE WITH

    behavior of partial replacement of fine aggregate in concrete by Granite fine. Granite fines are the byproduct of granite industries while cutting huge granite rocks to the desired shapes. The granite powder from factory is carried by the water and stored in tanks. After evaporation of water the granite dust remained in the tank.

  • (PDF) COCONUT SHELL AS PARTIAL REPLACEMENT OF COARSE ...

    The result showed that the concrete produced by replacing 18.5% of the crushed granite by coconut shells can be used in reinforced concrete construction. The use of coconut shell as partial replacement for conventional aggregates encouraged through the study as an environmental protection as well as construction cost reduction measure.Trial mix ...

  • Granite Slurry for Partial Cement Replacement in Concrete ...

    Different granite slurry wastes adopted by the investigators for cement replacement in concrete having specific gravity values ranging from 2.17 to 3.01.At the same w/b

  • AN EXPERIMENTAL ANALYSIS OF PARTIAL REPLACEMENT

    replacement of coarse aggregates and the remaining 18 cubes and 3 beams are 10%, 20%, 30%, 40% and 50% of ceramic as partial replacement of coarse aggregates. Besides that, all other parameters are constant. The concrete cube were tested as destructi ve test at last which is compression test

  • Partial Replacement of Coarse Aggregate with Broken ...

    Abstract The study reports on experimental investigation on the suitability of the use of broken tiles as partial replacement for crushed granite in concrete production. Control mixing ratio of 1:2:4 batched by weight with water cement ratio of 0.55 was used. The percentage replacement varied from 0% to 40% at intervals of 5%.

  • Experimental Study on Performance of M30 Grade Concrete by ...

    Dec 31, 2018· Granite powder is replaced in percentages of 0, 10, 15, 20, and 25 to that of fine aggregate. In addition to this 0, 10, 20, and 30 percentages of fly ash is also used as partial replace cement. For different percentages of replacement of granite and fly ash in concrete, the compressive strength is determined at 28 days.

  • EFFECT OF FLY ASH AND QUARRY DUST AS A PARTIAL

    under taken to produce low cost concrete by blending in various ratios of hypo sludge with cement. the concrete composition can also be suitable for partial replacement (up to 60%). the fly ash, quarry rock dust can be used form 20% replacement of cement and fine aggregate in concrete.

  • EXPERMENAL STUDIES ON M20 GRADE CONCRETE BY

    The overall test performance revealed that granite powder can be utilized as a partial replacement of natural sand in high Performance concrete. Oyekan G.L and Kamiyo O.M (2008) studied the performance of hollow sand create blocks containing cement, sharp sand and granite fines in varying propositions to determine their structural

  • Investigation on Strength Properties of Concrete with ...

    fine aggregate (sand) and cement were partially replaced with Granite powder and marble powder. The replacement is done by 5%, 10%, 15%, 20%, 25% of cement by marble powder and 5%, 10%, 15%, 20%, 25% of fine aggregate by granite powder to evaluate the effect of presence of these replacement materials on the strength of specimens.

  • Replacement of Coarse Aggregate by Demolished Brick

    In this present work the study on replacement of coarse aggregate by demolished brick aggregate. Coarse aggregate can be defined as inert granular materials such as gravel, crushed stone and sand. Coarse aggregate is one of the essential ingredients apart of water and cement in concrete production.

  • Durability Studies on Fibre Concrete Using Partial ...

    This granite powder waste can be utilized for the preparation of concrete as partial replacement of cement; an experimental investigation has been carried out on M20 grade concrete. The percentages of granite powder added by weight to replace cement by weight were 0, 5, 10, 15, 20,

  • Partial Replacement of Cement with Fly Ash In Concrete

    3. Ultimate compressive strength of concrete decreasing with increase in w/c ratio of concrete. 4. Slump loss of concrete goes on increasing with increase of quantity of fly ash. 5. The 10% and 20% replacement of cement with fly ash shows good compressive strength for 28 days. 6.

  • Characteristic Studies on Concrete by Partial Replacement ...

    Sep 10, 2019· In present study the detailed characteristic studies of concrete is carried out by partial replacement of natural sand by waste granite powder in concrete composition with different percentages (0%, 10%, 20%, 30%, 40%, 50%).The mechanical properties of concrete like compressive strength, tensile strength are carried out by replacing the ...

  • Use of Saw Dust Ash as Partial Replacement for Cement In ...

    Portland cement as an ingredient in concrete is one of the main construction materials widely used especially in developing countries. The increasing demand for cement is expected to be met by partial cement replacement (Coutinho, 2003). The search for alternative binder or cement replacement materials led to the

  • (PDF) Partial Replacement of Cement by Kota Stone Slurry ...

    This research work is concerned with the experimental investigation on strength of concrete and optimum percentage of the partial replacement by replacing OPC cement via

  • EXPERIMENTAL STUDY ON STRENGTH OF CONCRETE BY

    Study on Partial Replacement of Cement with Marble Powder And Fine Aggregate with Quarry Dust, International Journal of Civil Engineering and Technology, 8(6), 2017, pp. 774781. [13] Y. Mahesh Babu and P. Sundara Kumar, Strength and Behavior of High Volume Fly Ash and Replacement of

  • Research Paper PARTIAL REPLACEMENT OF CEMENT WITH

    PARTIAL REPLACEMENT OF CEMENT WITH MARBLE DUST POWDER Prof. P.A. Shirule a*, Ataur Rahman b , Rakesh D. Gupta c Address for Correspondence a*bc Dept. Of Civil Engineering, SSBTs COET, Bambhori, Jalgaon, Maharashtra 425001 ABSTRACT Leaving the waste materials to the environment directly can cause environmental problem.

  • (PDF) Use of Stone Dust & Granite Powder as a Partial ...

    The stone dust generated during the process of cutting and polishing is used as the partial replacement of cement (OPC-43). Granite Powder:Granite is an igneous rock which is commonly used as a building material in the field of construction in various forms.

  • USE OF PLASTIC WASTE AS A PARTIAL REPLACEMENT OF

    of industry by-product in concrete is as partial aggregate replacement or as partial cement replacement, depending on their chemical composition and grain size. In this study, the effects of use of such waste product on resultant properties of concrete mix are studied. This waste product is used as replacement of coarse aggregate. Key Words ...

  • EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF

    concrete, the water cement ratio used in the work is 0.45, which is obtained from the IS 10262. The concrete was cast in the form of cubes and cylinders with 0%, 10%, 15% and 20% replacement of cement by Ceramic tile powder. To find out the workability of concrete the slump test was carried out in the fresh concrete mix.

  • Granite or Quartz Countertop Overlays - The Spruce

    Jul 29, 2020· A small, niche industry makes granite or quartz countertop overlays that cover existing counters. A hard slab of granite, or quartz, including edges and backsplashes, goes on top of the existing countertop. These are variously called countertop overlays, granite counter units (GCUs), modular granite, or modular quartz. 01 of 06.

  • Strength and Durability Properties of Granite Powder Concrete

    They examine the possibility of using granite powder as replacement of sand and partial replacement of cement with fly ash, silica fume, slag and superplasticiser in concrete. The percentage of granite powder added by weight was 0, 25, 50, 75 and 100 as a replacement of sand used in concrete and cement was replaced with 7.5% silica fume, 10% ...

  • Properties of Hardened Concrete Produced by Waste Marble ...

    Jul 03, 2015· Marble is industrially processed by being cut, polished, and used for decorative purposes, and thus, economically valuable. ... Durability of concrete made with granite and marble as recycle aggregates. Journal of materials processing technology, 208 ... Study on marble dust as partial replacement of cement in concrete.

  • partial replacement of fine aggregate by glass powder in ...

    Apr 05, 2015· 1. PARTIAL REPLACEMENT OF FINE AGGREGATE BY GLASS POWDER IN CONCRETE. 2. OBJECTIVE: To evaluate the utility of glass powder as a partial replacement of fine aggregate in concrete. To study and compare the performance conventional concrete and glass powder concrete. To understand the effectiveness of glass powder in strength enhancement.

  • EXPERIMENTAL STUDY ON COIR BLENDED CONCRETE

    specimens. She examined the possibility of using granite powder as replacement of sand and partial replacement of cement with fly ash in concrete. The percentage of granite powder added was 0%, 25%, 50%, and 75% by weight as a replacement of sand used in concrete and cement was replaced with 10% fly ash. The water-cement ratios on

  • 12 Most Common Mistakes When Pouring Concrete | The Family ...

    Sep 04, 2020· The standard concrete recipe is one part cement, two parts sand and three parts clean crushed stone. Dont skimp. Crushed stone is filler, so dont use any more than the recipe calls for. In fact, use a little less stone proportionally if you have a hard time troweling a nice, smooth surface.

  • EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF

    2. Compressive strength increases at 30% replacement of ceramic tiles and decreases on increasing the proportion. So 30%of replacement is an optimum percentage. 3. The compressive strength of ordinary concrete is 25.9 N/mm2 and the increased strength in replaced concrete at 30% was 35.47N/mm2 at 28 days of curing. 4.

  • An Experimental Study on Partial Replacement of Sand with ...

    the behaviour of M20 grade concrete with the use of granite fines as a partial replacement for sand in 5%, 15%, 25%, 35% and 50%; and based onthe results obtained for compressive, split-tensile and flexural tests, it was recommended that 35% of sand can be replaced by granite fines.

  • Experimental Study of Partial Replacement of Fine ...

    used as partial replacement for river sand. The properties of the material investigated are presented in table 2. The size of the material used is 4.75 mm and down size. 2 Coarse aggregate: Machine crushed granite obtained from a local quarry was used as coarse aggregate. The properties of the coarse aggregate are shown in table 3

  • Strength and Durability Studies on Concrete Containing ...

    MALAVIYA NATIONAL INSTITUTE OF TECHNOLOGY JAIPUR CERTIFICATE This is to certify that the thesis report entitled Strength and Durability Studies on Concrete Containing Granite Cutting Waste as Partial Replacement of Sand which is being submitted by Sarbjeet Singh, ID: 2013RCE9021, for the partial fulfillment of the degree of Doctor of Philosophy in Civil Engineering to the Malaviya ...

  • Strength Characteristics by Partial Replacement of Cement ...

    with Partial replacement of brick powder at 0%, 5%, 10%, 15% and 20% to existing cement content. This paper investigates quantitavely the strength of concrete mix at different ages. The overall test results revealed that in concrete mixtures, Crushed Rock Powder can be fully

  • Experimental Study of Light Weight Concrete by Partial ...

    Partial replacement of Coarse Aggregate with different ratios of Pumice ranging from 50%, 60% and 70%. This study is focused to determine the strength parameters of light weight aggregate concrete to find the favorable replacement with the above mentioned

  • An Experimental investigation on utilizations of Marble ...

    3.2 COMPRESSIVE STRENGTH - Compressive strength of concrete mixes with various percentage of marble dust as replacement of cement at age of 7 days and 28 days respectively are shown in Fig.3 and Fig.4. From Table 10 and 11 it can be observed that with the replacement of cement with marble dust for 5% & 10% there is an increase in the strength at 7days as well as at 28 days.

  • Strength Properties of Concrete with Partial Replacement ...

    used as a partial cement replacement material in concrete it will be a valuable resource. T. Ramos et al studied the effect of granitic sludge from a terms of strength and durability, so as to envisage its use in concrete. [1] The granite rock sludge was analyzed as cement replacement for strength and durability testing, for alkali-silica

  • EXPERIMENTAL INVESTIGATION ON LIGHT WEIGHT

    Concrete cylinders of size 150 mm diameter and 300mm length were cast with incorporating copper slag as partial replacement of sand and cement. During casting, the cylinders were mechanically vibrated using a table vibrator. After 24 hours, the specimens were de-moulded and subjected to curing for 7 days, &28 days in portable water. After curing,

  • Project on Partial Replacement of Cement with Marble Powder

    This project describes the feasibility of using the marble sludge dust in concrete production as partial replacement of cement. In INDIA, the marble and granite stone processing is one of the most thriving industry the effects if varying marble dust contents on the physical and mechanical properties of fresh and hardened concrete have been ...

  • EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF

    replacement in concrete shows good results on compressive strength, flexural strength, split tensile strength and durability characteristic compare to control concrete. Similarly the percentage of quarry dust added by weight was 0, 15%, 20% and 25%, respectively the fine aggregate replacement in concrete. From this experimental results

  • REPLACEMENT OF CEMENT WITH DOLOMITE POWDER: AN ...

    Replacement of cement with dolomite powder is found to improve the strength of concrete. The maximum replacement percentage of cement with dolomite powder is found to be 5% and at this replacement level, the maximum increase in the 28th day compression and flexural strength were found to be 5.84% and 2.73% respectively.

  • Partial Replacement of Cement With Marble Powder in Concrete

    In this paper explained about the behavior of concrete with partial replacement of cement with added percentage values of marble powder and attain required strength. Partial replacement of marble powder in cement accordingly in the range of 20%, 30%, 40%, by weight for M20 grade of concrete.

  • Experimental Study of Partial Replacement of Cement with ...

    A. Aim: To find the effect of partial replacement of cement with eggshell powder in concrete. B. Objectives: The objectives of this work is as follows: 1. To study the optimum mix proportion of partial replacement of eggshell powder for cement in concrete 2. To study the behavior of concrete specimen with the percentage variation of eggshell as ...

  • An Experimental study on partial replacement for coarse ...

    S.NO concrete type coarse aggregtae replacement with granite waste 1 C0 Standard concrete 2 C1 10% replacement 3 C2 20% replacement 4 C3 30% replacement 5 C4 40% replacement 6 C5 50% replacement EXPERIMENTAL SETUP: Experiment methodology: The evaluation and replacement of granite waste for coarse aggregate are done by